|Need instructions on applying an orthopedic fiberglass or plaster leg or arm cast. Try one of our links below. There are a variety of orthopedic casting techniques to ensure you get the best leg cast or arm cast application. There are instructions on the net to help aid in the removal of an orthopedic cast as well. There are many orthopedic technician groups on the net that can help you develop your casting skills. Because orthopedic casting takes skill, you may find you need to practice a few times before the cast is well formed.|
A quick application video to show you how to use the OrthoTape casting tape:
Tips and tricks for getting the perfect cast with OrthoTape brand fiberglass casting tape.
You will find that OrthoTape fiberglass casting tape has a higher resin content than other casting tapes you may have tried. Often this is a catch-22, the less resin, the less it wants to stick together, the softer the cast. It also wants to unroll too fast and often falls out of your hand during application. The more resin the tape has, the more tacky it becomes, you may have to use different techniques such as unrolling then wrapping to avoid wrapping the cast too tight. Resin content in OrthoTape brand allows the tape to bind better to the other layers giving it the perfect lay down for that last roll on a finished cast. Often you will find some tapes that are loosely rolled or do not have a high resin content, they are less tacky or sticky. When this is the case, we have found that it tends to want to unroll too fast. Sometimes you will find it slips out of your hand and on to the ground and unrolls. That last layer at the end of the cast never wants to bind.
It is this reason we developed a tape with a higher resin content.
Here are some tips to help you roll the perfect cast:
1. Always use cooler water. This will give a slower set time allowing you time to work your magic with our tape.
2. Because it has a higher resin content, you will want to unroll a little bit and then wrap the limb. Unroll then wrap. This will keep you from rolling the cast too tight. But it also helps keep the roll under control rather than falling out of your hand.
3. OrthoTape brand is rolled a little tighter on the roll. Looser brands tend to unroll in the pouch if they are not rolled tightly. With this being the case, you will want to soak OrthoTape fiberglass a little longer in cold water and squeeze it about 3-4 times while dipped in water. This will allow water to flow to the middle and loosen the tape up.
4. During the application and after each roll. Dip your hands in water and rub the cast. This will cause it to bind together better and allow you to smooth out any wrinkles.
5. OrthoTape has a set time of about 4-5 minutes. Cooler water slows that process. Realize that if you open the pouch it will began to become solid due to the humidity in the air. So you have to use it right away.
6. Also at times, during manufacturing or transport. Little pin holes may develop in the packaging. We try very hard to check each roll to make sure they have not already hardened in the pouch. Sometimes they escape our notice. So if you find one, please save it and take a photo of it and we will send you a replacement or refund for that defective roll.
Casting tape is temperamental, but with practice you will find yourself an expert in no time.
After feedback from customers. We will be lowering the resin content slightly in the next batch. We are constantly striving to create the perfect cast tape. Realizing that some customers want it one way, and other customers want it the other. We hope to find a happy medium for both customer types.
How to apply a short arm cast.
| How to apply a long leg cast.|
View more Application instructions at the link below: